Products Temperature Sensors & Transducers Pressure Transmitters Wind Speed & Direction Current Transducers & Switches Moisture Meters Process Control Instruments Signal Converters, Power Supplies, Binding Posts Custom Sensors
View Cart View RFQs Express Ordering  | Shipping 
 | Tax 
 | Terms
 Shopping Cart 0 Items
 Request for Quote 0 Items
All Categories > Temperature Sensors & Transducers > Immersion Temperature Sensors > Order # TS-P-6-T-10K  
Download PDF Download PDF     Printable Page     Email Email This Page     Save To Favorites Save To Favorites
Add To Cart Request Quote

Order # TS-P-6-T-10K, Immersion Temperature Sensors

Base Price $54.00

  • Spring Loaded
  • Moisture sealed
  • Hinged cover case
  • Platinum RTD or Thermistor

    This probe is used to measure the temperature of fluids or gases in pipes. We spring load these probes to provide a good thermal contact with the base of the mating thermowell ensuring fast and accurate measurements. The temperature sensor which is PC board mounted for better reliability is potted in heat transfer compound for rapid response and vibration protection. Our moulded case with hinged cover is easy to install. It is designed to accept a 2-wire transmitter.
    Matched Pairs: On request 1/3 DIN RTD’s provide 1/10th deg C accuracy for energy consumption calculations.

    Platinum RTD's are the most stable temperature sensors between -50 and 400C. They show almost no calibration drift with time. Their stability, wide temperature range and almost linear output make them the choice in demanding applications.
    NTC Thermistors are the most sensitive sensors known for measurements from -50C to +150C. Their temperature coefficient can be as high as several percent per degree C. This means that lead resistance from installation of thermistors in remote areas has minimal effect on accuracy.

    Retrofit Work
    Our step down adaptor model BUSHING-8-W, allows fast and easy retrofitting of new sensors to older systems with installed pipe thermometers or bulb and capillary thermometers. This is a brass step-down bushing to reduce the 1-1/4-18 UNEF thread commonly used on these older systems to the 1/2" NPT thread used by our pipe thermometers. Each is supplied with a brass sleeve to adapt the 1/4" stem to the 0.385 bore of the well.

    Operating Temperature
    The construction of these sensors limits their maximum operating temperature to 105C.

  • Technical Data

    Sensor Type


    Sensor Value

    10k ohms

    Stem Length (")



    CW - Chilled Water Pipe($10.00)

    Add To Cart Request Quote
    Site created by ThomasNet Web Solutions
    Company Name - Your Tagline Goes Here